Psion OMNII Uživatelský manuál Strana 246

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 358
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 245
C-6 Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
Appendix C: Bar Code Settings
Restoring Default Settings
Keep in mind that some bar code types are only available when an internal imaging scanner
is installed. All internal scanners can be configured using these dialog boxes.
C.1.2 Restoring Default Settings
If you want to restore the factory defaults after making changes, the defaults can be applied
to a selected parameter, sub-tree of parameters, or all scanner parameters.
Press and hold on a symbology (e.g., Code 128) to display a pop up a menu.
Choose Default subtree to reset only the parameters in the symbology you selected, or
choose Default all settings to reset all scanner parameters to default settings.
To reset a single parameter to its default setting:
Press and hold on the parameter you want to reset.
Note: Your Omnii comes preconfigured from the factory for internal scanner types. The
type of scanner installed can be determined from the System icon in the Control
Panel, under the System Properties tab.
Important: To improve the decode speed and performance, enable (set to ‘on’) only
those codes that are required by the application.
Zobrazit stránku 245
1 2 ... 241 242 243 244 245 246 247 248 249 250 251 ... 357 358

Komentáře k této Příručce

Žádné komentáře